Permits & approvals

Flooring Rules in NYC Co-ops and Condos: Acoustic Underlayment, Sound Ratings and Carpet Requirements

What NYC co-op and condo buildings typically require before you replace floors: acoustic underlayment, STC and IIC sound ratings, the rug coverage clause, board approval, testing, cost and schedule.

By Bayview Development & Management · Updated · 6 min read

Short answer

Most NYC co-ops and condos let you install hard floors, but only over an approved acoustic underlayment, and many proprietary leases still contain a clause requiring rugs over a large share of the floor, often 80% of each room except kitchens, baths and closets. The NYC Building Code sets STC 50 and IIC 50 (lab-tested) for floor/ceiling assemblies between apartments in new work. Get the building’s flooring requirements from the managing agent before choosing a product, because the underlayment changes floor height, cost and schedule.

Bright living room with oversized black steel windows and wide-plank oak floors at 31 Bayview, Jersey City
31 Bayview · Jersey City, NJ

Why buildings care about your floor

Noise complaints from the apartment below are among the most common disputes in NYC co-ops and condos, and the floor is usually the cause. Replacing carpet with hardwood, or old wood with tile, can make footsteps and dropped objects far louder downstairs. Boards and condo associations respond in two ways: they write flooring requirements into the alteration agreement, and they keep older lease clauses that require rugs. If you are planning other work too, our co-op and condo renovation guide covers the overall approval process.

The two sound ratings you will hear about

RatingWhat it measuresNYC Building Code minimum for new floor/ceiling assemblies between units
STC (Sound Transmission Class)Airborne sound: voices, TV, music50 lab-tested (ASTM E 90), or 45 if field-tested (ASTM E 336)
IIC (Impact Insulation Class)Impact sound: footsteps, dropped items, chairs50 lab-tested (ASTM E 492), or 45 if field-tested (ASTM E 1007)

Higher numbers are quieter. For flooring work, IIC is the one that matters most, because hard floors transmit impact noise directly into the structure. Note that the rating applies to the whole assembly: slab, underlayment, finish floor and the ceiling below. An underlayment manufacturer’s published IIC is measured on a specific test assembly, so a product that achieves IIC 60+ in a lab on a slab with a suspended ceiling may perform differently on a bare prewar slab. Many buildings set their own target, sometimes above the code minimum, and some specify approved products by name.

The carpet or rug clause

Many older NYC proprietary leases contain a clause requiring that a large portion of each room, commonly 80%, be covered with carpet or rugs over padding, excluding kitchens, bathrooms, closets and foyers. Some buildings enforce it strictly, some only after a complaint, and some have replaced it with an underlayment requirement through house rules. Check three documents:

  • Proprietary lease (co-ops) or bylaws and rules (condos): the rug clause, if any.
  • House rules: may modify or add to the lease clause.
  • Alteration agreement: the technical requirements for new floors, the approved underlayments and whether testing is required.

If the building enforces the rug clause, a better underlayment will not exempt you from it. If you are buying, ask about enforcement before you plan an all-hardwood apartment.

What alteration agreements typically require

  • Submittal: a product data sheet for the underlayment and finish floor, often with the manufacturer’s test report, reviewed by the building’s architect or engineer.
  • Minimum performance: a stated IIC or a list of approved products.
  • Installation details: perimeter isolation strips so the floor does not touch the walls, no fasteners through the underlayment into the slab, and sealant at the edges.
  • Inspection: the super or building engineer may inspect the underlayment before the finish floor goes down. Leave time in the schedule for that visit.
  • Field testing: some buildings reserve the right to test after installation, especially after a complaint, and to require remedies if the floor fails.
  • Work hours and noise: demolition and floor removal limited to weekday hours; see the alteration agreement for the specifics.

Choosing an underlayment

TypeTypical useNotes
CorkUnder engineered wood and tileTraditional, widely accepted by buildings; thickness affects rating
Rubber or recycled rubber matsUnder tile, stone and woodOften the best impact performance per inch
Felt and foam compositesUnder floating engineered wood and vinylThin and inexpensive; check the building accepts it
Sleeper or floated subfloor systemsHigh-performance or uneven slabsRaise the floor more; used where buildings set high targets

The underlayment adds roughly 1/8 to 1/2 inch, or more with a floated subfloor. That affects door bottoms, thresholds into hallways, the dishwasher height in the kitchen and transitions to bathroom tile. Plan the total floor build-up early. In 2026, acoustic underlayment commonly adds roughly $1.50–$5 per sq ft installed to the flooring cost, more for floated systems. Treat that as a planning range, not a quote.

Kitchens and bathrooms

Rug clauses usually exclude kitchens and bathrooms, but alteration agreements generally still require underlayment under tile in those rooms. In bathrooms, the waterproofing membrane and the acoustic layer have to work together, and the building may require a flood test of the membrane before tile goes down. In kitchens, coordinate the flooring and underlayment with the cabinets: see our kitchen flooring guide for whether floors should run under the cabinets.

Permits, old floors and hazardous materials

Replacing finish flooring alone generally does not need a DOB permit, but board or association approval is still required, and flooring is often part of a larger alteration that does. Before old floors come up:

  • Asbestos: older vinyl tiles, sheet-flooring backing and mastic can contain asbestos. In NYC, building owners are responsible for having an asbestos survey done by a DEP-certified investigator when work may disturb it, and managing agents commonly require the survey report before work starts.
  • Lead paint: in buildings built before 1978, removing painted baseboards and saddles can disturb lead paint; contractors must follow EPA’s RRP rule, and NYC buildings often add their own lead-safe requirements.

Condos in Jersey City and Hoboken

Hudson County condo associations commonly have similar rules in their master deed, bylaws or rules and regulations: an approved underlayment, sometimes a minimum IIC, and association approval before work. The process is usually lighter than a Manhattan co-op, but the noise complaint risk is the same. Our Jersey City and Hoboken condo guide covers the association side.

Cost, schedule and value

Acoustic requirements add material, labor and usually one inspection to a flooring job, and the submittal review can take one to several weeks depending on the building. In return, a documented, approved floor is easier to defend if a neighbor complains and is a plus when you sell: buyers and their attorneys increasingly ask whether past alterations were approved and closed out. Keep the approval letter, product data and any test report with your apartment records.

BDM prepares flooring submittals, installs approved underlayments to the manufacturer’s details and schedules the building’s inspections as part of apartment renovations in Manhattan, Brooklyn and Queens and Hudson County. Send us your building’s alteration agreement through the project intake page.

Frequently asked questions

Can I put hardwood floors in a NYC co-op?

Usually yes, over an acoustic underlayment the building approves. Check the proprietary lease and house rules first: many older leases require rugs over a large share of each room, often 80%, excluding kitchens and baths.

What IIC rating do NYC buildings require?

The NYC Building Code sets IIC 50 lab-tested, or 45 field-tested, for new floor/ceiling assemblies between dwelling units. Many co-ops and condos set their own target or list approved underlayment products in the alteration agreement.

What is the 80% rug rule in NYC apartments?

It is a clause in many proprietary leases and house rules requiring carpet or rugs over a set share of each room, commonly 80%, to limit noise to the apartment below. Kitchens, bathrooms, closets and foyers are usually excluded.

Do I need a DOB permit to replace floors in my apartment?

Replacing finish flooring alone generally does not need a DOB permit, but co-op or condo approval is still required. Flooring is often part of a larger alteration that does need permits.

How much does acoustic underlayment add to flooring cost?

In 2026, roughly $1.50–$5 per sq ft installed for common cork, rubber or composite underlayments, more for floated subfloor systems. These are planning ranges, not quotes.

Sources & further reading

Costs are 2026 planning ranges for the New Jersey and New York City market, not quotes. Rules summarized here change and vary by building and municipality; confirm requirements with your local building department, building management or attorney before you start.

About the author

Bayview Development & Management is a licensed and insured general contractor and real estate developer founded in 2022, with completed projects in Jersey City and Manhattan. BDM is also a full-service ADU (accessory dwelling unit) builder, handling zoning, design, engineering, permits and construction, with completed and in-progress ADUs in Jersey City. Contracting services · ADU · Portfolio

Start a project

Ready to start?

Describe your project, upload photos and book a call with BDM.